8418
Views
10
Helpful
3
Replies

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2019 07:20 PM - edited 02-21-2020 08:49 AM
Solved! Go to Solution.
Labels:
- Labels:
-
Firepower Threat Defense (FTD)
1 Accepted Solution
Accepted Solutions
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-15-2019 08:11 PM
Ok no problem. Let me know when you've tested.
For FTD, this is the procedure when using FMC. If you have FDM, you can use the same command as ASA but you need to use Flexconfig object to push it.
Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question
For FTD, this is the procedure when using FMC. If you have FDM, you can use the same command as ASA but you need to use Flexconfig object to push it.
Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question
3 Replies 3
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2019 08:46 PM
Hi
On ASA, the command is:
ip verify reverse-path interface interface_name
Take a look at this documentation:
https://www.cisco.com/c/en/us/td/docs/security/asa/asa91/configuration/firewall/asa_91_firewall_config/protect_tools.html
For FTD, when you're in the interface config, you should find the ip spoofing parameter under security tab within advanced options.
Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question
On ASA, the command is:
ip verify reverse-path interface interface_name
Take a look at this documentation:
https://www.cisco.com/c/en/us/td/docs/security/asa/asa91/configuration/firewall/asa_91_firewall_config/protect_tools.html
For FTD, when you're in the interface config, you should find the ip spoofing parameter under security tab within advanced options.
Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-15-2019 06:56 PM
Thank you very much for your reply.
I will try it out.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-15-2019 08:11 PM
Ok no problem. Let me know when you've tested.
For FTD, this is the procedure when using FMC. If you have FDM, you can use the same command as ASA but you need to use Flexconfig object to push it.
Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question
For FTD, this is the procedure when using FMC. If you have FDM, you can use the same command as ASA but you need to use Flexconfig object to push it.
Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question
