cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
636
Views
0
Helpful
2
Replies

HUM Live - Graph It - Not working

brianhill88
Level 1
Level 1

Hello,

I'm using LMS 3.2 with HUM 1.2. I'm trying to utilize the HUM Live - Graph it. We actually had it working at one point but now whenever I try to monitor the route processor of our switch I get the following mesage:

"The instance CPU of Routing Processor 6 has been renamed for the variable cpmCPUTotal5minRev" and then "No data to display"

I've also tried to monitor different devices and different MIBs but always get some kind of error like "unable to contact device" "No data to display" or sometimes the graph comes up and just sits there blank. Any ideas what might be causing this?

Thanks

2 Replies 2

auraza
Cisco Employee
Cisco Employee

Is SNMP configured correctly on the devices that you are trying to poll?

Yes. All the other portions of LMS work correctly with those devices (DFM, RME, etc.), even other portions of HUM. Just not the HUM Live - Graph It.

Review Cisco Networking for a $25 gift card