ICMP drooped After applying NAT between sub interfaces
Hello , I am trying to connect ASA firewall to a switch as firewall on stick
pc1 (Vlan 10) ---------
switch ----------- ASA
pc2 (Vlan 20 ) ---------
int g0/0 no ip add int g0/0.10 vlan 10 ip add 10.10.10.1 255.255.255.240 nameif Inside_1 security 100 no shut int g0/0.20 vlan 20 ip add 10.10.10.17 255.255.255.240 nameif Inside_2 security 100 no shut
this is my configuration when i try to ping PC1 to 2 or vise versa its works
but the issue that ( i want pc2 to see PC1 as 18.104.22.168)
#Object for PC1_NAT Object network Ip_7 host 22.214.171.124
nat (Inside_1,Inside_2) source static Ip_PC1 Ip_7
the ping fail PC1 send request to 2 , PC 2 replay to 126.96.36.199 then packet is droped only from PC2 side
i tried to ping PC1 from PC2 as ping 188.8.131.52 only request send to gateway
Hello! I run 184.108.40.206.When I click download updates in ASDM I get:Download updates failed: Peer certificate cannot be authenticated with known CA certificates I have 3 identical devices and all of them have the same problem.. How can I fix ...
You would like to use the ASA Firewall Umbrella Connector to enforce DNS policy with Umbrella. However you would also like to exclude certain IP addresses or subnets from using this policy. I recently had the need to do this, had a bit of tro...
Hi Everyonem Just wondering if anyone knows why I am getting an error that says "Cryptographic algorithms required by the secure gateway do not match those supported by AnyConnect. Please contact your network administrator.". See attached...
The Cisco 2020 CISO Benchmark Report provides valuable takeaways and data on the most pressing topics: the impact of vendor consolidation, cybersecurity fatigue, outsourcing, top causes of downtime, the most impactful threats, and more. The repo...
Hi, Has anyone run into the "Channel down" issue when updating the identity certificate on the Stealthwatch SMCv and SFCv. I'm doing a POC for a client and every time I go an update the identity cert the SMC says "it could save the configuration" and...