Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
433
Views
0
Helpful
1
Replies

IDSM-2, SW 6.1(1)E3 Issues????

jphilope
Level 3
Level 3

‎11-05-2008 02:30 PM - edited ‎03-10-2019 04:22 AM

We have auto update configured on our IDSM-2 and monitor with the IME. Since the upgrade to Engine 3 and the latest signatures autoposted today, we notice on the IME it will stop monitoring, all lines will go flat and eventually all gadgets will go blank. Takes about an hour. Anyone else seeing this behavior?

Tomorrow, I retrograde!

Labels:
0 Helpful
1 Reply 1

jphilope
Level 3
Level 3

‎11-06-2008 08:48 AM

Well, instead of retrograding, I upgraded. Now running 6.2(1)E3 and IME 6.2. This appears to have resolved the issue.

Hope this helps someone else out.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card