Initial setup ASA 5525-X

[Sergey Prishchepa]

There ASA 5525-X ios 8.6, mode routed. I ran the command clear configure all. Now, at the interfaces can not configure even ip address.

Ip neither here ciscoasa (config) # no management at the interface. No and commands configure factory-default.

What's the problem?

[lcambron]

Hello,

We will need more information abou the issue:

what are the commands you are using?

what error do you get?

Regards,

Felipe.

[Sergey Prishchepa]

If you enter ciscoasa(config-if)#ip? or (config)#ip? or (config-if)#nameif?

Writes: ERROR:% Unrecognized command

[i.va]

FYI - I recently installed an ASA5525-X and had problems with v8.6.1 and NAT. Only an Upgrade to v9.1.1 fixed the issue. So if you do alot of NAT, then I would suggest an upgrade.

I know this doesnt answer your question, but it might save you some time in case of troubleshooting.

[Sergey Prishchepa]

Thank you'll be aware

[Sergey Prishchepa]

solution:

ciscoasa (config) #mode single