Interface for CX module
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-12-2013 01:13 PM - edited 03-11-2019 08:17 PM
Do i have to use the Management port to configure the CX module, also is there any other way to access the ASA 5515 CX module other than accessing it via managemnt port, i dont want to terminate the management port on to my l2 swithc . But the issue is I am configuring the ASA remotely , I can access the ASA but not the CX module,
- Labels:
-
NGFW Firewalls
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-12-2013 03:47 PM
Other than the minimal initial setup that you do from the ASA itself, all of the PRSM-based configuration (policies etc.) must be done via login to the management port. This applies whether using the built-in PRSM ("on box") or an external PRSM server ("off box").
