04-03-2009 07:23 AM - edited 03-11-2019 08:14 AM
Hi, we have two internal 5505 firewalls protecting our emergency services subnets from the rest of the organisation. The setup is quite simple, allow all traffic to pass between the two protected sites but nothing else. The Interface facing the organisation and hence my PC which is used for configuring is the External interface. The problem I have is getting Telnet and SSH access to the device through the external interface. I understand i need to setup IPSEC on this but basically I dont know how to. Can some kind soul point me in the right direction? Either a relevant document or some simple steps for a dummy?
Thanks, Ray
04-03-2009 07:51 AM
Ray,
Below are some config examples, all you need is on this link:-
http://www.cisco.com/en/US/products/ps6120/prod_configuration_examples_list.html
HTH>
04-03-2009 08:15 AM
you can ssh to the external interface w/o having to go over ipsec, not the case w/ telnet.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide