IPSEC problem between Cisco Router and Netscreen 5GT

[D]

isakmp is working.

fase 2,Ipsec does not work:

IPSEC(validate_proposal): transform proposal (prot 3, trans 3, hmac_alg 1) not supported

[carenas123]

To my knowledge, the problem might be the transform set mismatch or the tunnel group mis match name.

This document provides an explanation of common debug commands that are used to troubleshoot IPsec issues on both the Cisco IOS? Software and PIX. It is assumed that an attempt to configure IPsec is completed. Refer to Common IPsec Error Messages and Common IPsec Issues for more details.

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_tech_note09186a008009448c.shtml