Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi. I need to enable port 25 on a Cisco 837 router and redirect it to an internal mail server. The server is currently using Exchange 2003 and it's role is changing from picking up POP mail to having SMTP mail directed to it. I'm OK with getting the ...

Is it possible to NAT to 1 of 2 different inside destination IP's based solely on the external source IP address?There is something similar described but it doesn't work:access-list WEB permit tcp host 10.1.2.1 209.165.201.11 255.255.255.255 eq 80acc...

Hello All, The scenario is as below.I've a server on the inside interface whose default gateway is a router (which is still behind the PIX)The actual config on the server should have been a default gateway pointing to the PIX rather than the router.I...

rajeshiyer by • Community Member
  • 519 Views
  • 1 replies
  • 0 Helpful votes

I have two 6500s (primary/secondary w/ HSRP) and one IDSM. I want the IDSM to monitor the inside interface of two firewalls (active/standby). One firewall inside interface connects to one 6500 and the other firewall to the other 6500. The firewalls a...

rmeans by • Level 6
  • 682 Views
  • 1 replies
  • 0 Helpful votes

I have a ASA 5540 and currently two route statements one for the inside traffic and the other a DF route to the outside. The ACl I have is an extended ACL allowing IP to any any applied to the in interface inside, out interface inside. Yet I can not ...

Resolved! PIX Image

I copied all my firewall configurations to a tftp server. Now I was thinking that it would be a good idea to copy the PIX image but I cannot seem to get it to work. I was able to copy the IOS for my routers without a problem. I found a Cisco article ...

dexteroc1 by • Level 1
  • 1088 Views
  • 2 replies
  • 0 Helpful votes

This signatures seems to fire towards FTP servers with a welcome message before the login prompt.E.g.Connected to 127.0.0.1.220-##220-##220-*--------------------------------------------------------------------------------*220-*-----------------------...

m-hansson by • Level 2
  • 2126 Views
  • 10 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card