ipsec vpn spa

[judd_alberts]

we have a cisco 7600 with vpn spa module, and i have to specify ip address on switch outside port for example on GigabitEthernet 4/48 (swicth outside port).

Now i want configure vpn spa module,i know i must configure port vlan (layer 2) and interface vlan (layer 3).

then connect switch outside port to vpn module by crypto-connect vlan command.

But when use this command on interface GigabitEthernet 4/48 show following message:

interface 4/48 has a ip address.

and in debug isakmp sa display following messages:

6d20h: %ACE-3-NOENGINESLOT: Interface GigabitEthernet4/48 has no crypto engine slot

6d20h: ISAKMP: Unable to get connection id for slot 0!

i have to Specify ip address on Gigabitethernet 4/48 .(network design)

Thanks your advice

[jsivulka]

An IKE SA was requested for a given interface, but no crypto engine slot was assigned to that interface

Configure the interface in question by entering the crypto engine [sub]slot command.

http://cisco.com/en/US/products/hw/switches/ps708/module_installation_and_configuration_guides_chapter09186a00805f37bf.html#wp1045602