cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
678
Views
0
Helpful
1
Replies
Beginner

Is there a command to know the current throughput fo an IPS

Hi guys

I need to get some information from my CISCO IPS. I need to get the current throughput from the IPS but I cannot find any command that could bring such information.

If somebody know how to get this information it will be great.

Regards!

Everyone's tags (5)
1 REPLY 1
Highlighted
Rising star

Is there a command to know the current throughput fo an IPS

I had a script that would log in, run a "show stat analysis" twice, 60 seconds apart. Then it would pull the byte count from the interfaces, subtract the smaller number from the larder, device by 60 (seconds) and multiply by 8 (bytes to bits).

Results in b/s for each interface.

- Bob