Is there a command to know the current throughput fo an IPS

[Luis Carranza]

Hi guys

I need to get some information from my CISCO IPS. I need to get the current throughput from the IPS but I cannot find any command that could bring such information.

If somebody know how to get this information it will be great.

Regards!

[rhermes]

I had a script that would log in, run a "show stat analysis" twice, 60 seconds apart. Then it would pull the byte count from the interfaces, subtract the smaller number from the larder, device by 60 (seconds) and multiply by 8 (bytes to bits).

Results in b/s for each interface.

- Bob