ISE 2.3: Operation failed: Validation Errors: Device profile configuration is invalid: No dynamic URL attribute-value pair specified

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-31-2017 08:52 AM
Cisco ISE 2.3 Question:
I am trying to add a new 3rd Party Network Access Device Profile with its Vendor-Specific RADIUS dictionary. I am able to successfully configure Change Of Authorization (CoA) choices with the Vendor-Specific RADIUS dictionary attributes, but when I get to Redirect choosing Dynamic URL, I am only able to choose RADIUS dictionary attributes (RFC 2865) and not the Vendor-Specific RADIUS dictionary. When I try to manually type in the Vendor-Specific RADIUS dictionary attribute that I want to choose from the pull-down, I get a pop up with the error
Operation failed:
Validation Errors: Device profile configuration is invalid: No dynamic URL attribute-value pair specified.
Afterwards, I am unable to update/submit the NAD Profile that I am trying create and have to exit without saving any its configuration.
Even if I were include Cisco in the RADIUS Dictionaries, the Redirect Dynamic URL Cisco Dictionary Attributes are not even showing up.
How can I properly configure a new 3rd Party Network Access Device Profile with its Vendor-Specific RADIUS dictionary.
- Labels:
-
Identity Services Engine (ISE)

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-10-2017 05:43 PM
Suggest you move this post out of the DevNet area which is more for APIs / software integrations and over to the Identity Services Engine (ISE) group for general network access questions. I would do it for you but I don't have the privileges under Actions.
