cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
751
Views
0
Helpful
3
Replies

Issue while going to context through Switch...

shain bharati
Level 1
Level 1

Hi,

when i go to the context through switch then i am not able to do anything. i am able to go to one context but then the session gets locked, means i can not run any command not even go back to the system context or any context. i have to close and open a new session.

i get this messege: not authorised.

I can acces FWSM directly but not through SWITCH.

Please help me.

Thanks in advance,

Shain Bharati CCIE (R&S) #28837       

3 Replies 3

Jennifer Halim
Cisco Employee
Cisco Employee

"Not authorised" seems to imply that you have configured authorization to disallow access.

Can you share the system and admin context config.

Jennifer,

this is aaa configuration,

---------------------------------------------------------------------------

aaa authentication enable console ACS LOCAL

aaa authentication ssh console ACS LOCAL

aaa authentication http console ACS LOCAL

aaa authorization command ACS LOCAL

aaa accounting enable console ACS

aaa accounting ssh console ACS

aaa accounting telnet console ACS

aaa accounting command ACS

------------------------------------------------------------------------------

I just removed 

aaa authorization command ACS LOCAL

and working fine, but this is temparory solution, we do not want to remove this command.

please let me know if you have some permanent solution.

Thanks,

Shain Bharati

Since authorization is done by ACS server, you would need to check what you have configured on the ACS server that has prevented the access.

Review Cisco Networking for a $25 gift card