Juniper netscreen to ASA conversion

[punit.dixit]

Hi,

does someone has any case study where juniper netscreen has been replaced with cisco ASA?

rgds

[ayman.abdalla]

Thanks Rajesh,

the email was sent from my personal account, "aymanov1@hotmail.com"

have a nice weekend

[secureIT]

Hi Ayman,

Your configuration is so huge & i dont have enough time to go thru it.... I had taken almost 3 days to study and prepare the ASA CLI configuration for my earlier project. So i shall upload the JUNIPER & CISCO ASA converted configuration of my ealier project.

All the Ip addresses and networks have been replaced with fake ip address in both the text files for security perspective.

All of you members can go thru each of the configurations and match it. Those who are not familiar with juniper cli, should take a backup of policy screen shots and prepare for ASA.

There are slight changes in both the configurations i prepared, since customer wanted to remove unwanted configurations from it & fine tune it.

For any troubelshooting / requirements you may update the case notes, i shall reply once i get time.

Hope all of you will enjoy it...

regards

Rajesh P ... (CCSP)

[ayman.abdalla]

Thank you very much Rajesh for this valuable information.

I really appreciate your efforts to come up with these two documents. It will save me a lot of long working hours on Juniper manulas

i will start working on it and if i find any obstacles, i will let you know.

[racquel.mays]

Thank you soooo much you have really given me a good basis for my juniper to asa migration!  Thank you again for providing the files.

[secureIT]

You all are welcome...

Guy pls rate if this thread helped you...im sure all of you would have enjoyed it.

[Sonain Zia]

Hi,

Is there any tool available to convert Juniper SSG config to Cisco ASA or Cisco IOS FW?

Thank you,

Sonain

[Anand Kanani]

Here is the new self-service tool that Cisco has released to convert to any vendor firewalls to Cisco ASA.

Currently it supports Juniper ScreenOS and CheckPoint to Cisco ASA conversion.

Link to the original post:

https://supportforums.cisco.com/community/netpro/security/firewall/blog/2013/09/27/conversion-tool-juniper-screenos-to-cisco-asa

Link to the tool itself:

https://fwmig.cisco.com