Network Security

Engage with peers and experts on network security topics such as FTD, FMC, FDM, CDO and ASA.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hello      how i can Achive one way Connection without Leave the Higher Security Level Allowed to go to any Less Secure Area     for Example i have 2 Servers and One Firewall i need to Open into the Trusted Network Port TCP/5450 so the server in the ...

Hi everyone,I am trying to ASDM to ASA  which has l2 tunnel connectionPC  ASA1 ---------------------------------L2 tunnel  ASA  2When i try asdm to ASA2  ASA1 log shows syn timeout to IP 10.31.2.81 which is Management IP of ASA 2ASA 2 has no nat conf...

mahesh18 by Level 6
  • 17656 Views
  • 8 replies
  • 0 Helpful votes

Hello      i just wannan be Sure About the ASA H/A behavior when is failover      i have 2 Unit ASA5510 Security plus running on Active Stand by , and on the Unit itself i configure 2 Redundant Interfaces so one is active and the      other one remai...

Resolved! ASA Upgrade advice

Hi,we have large amount of ASA on version 8.4 and some on version 7.2. Most devices are 5510, 5520, 5540.Please advice do we really need to upgrade to version 9 or if we make 8.4(2) as our standard, it will be fit for the purpose.What are the convinc...

raza555 by Level 3
  • 720 Views
  • 1 replies
  • 0 Helpful votes

Hi,Am replacing the Pix 515E firewall with a ASA 5515 firewall. When givingthe below commands:nat-controlglobal (dmz) 1 interfacenat (inside) 1 10.1.11.0 255.255.255.0static (inside,dmz) 172.19.176.91 10.1.11.41 netmask 255.255.255.255static (inside,...

Hello everyone-I have an ASA-5585-SSP-10 that I have subinterfaces and VLANs created on. I used this ASA to firewall the vlans downstream on our Catalyst 4k's. Most all of my interfaces have specific ACLs in for the necessary traffic and all is good....

I have a Cisco CGR 2010 router running CGR2010-UNIVERSALK9-M, Version 15.2(3)T. I have been unable to locate the SCADA signatures mentioned here: http://www.cisco.com/en/US/prod/collateral/routers/ps10967/ps10977/whitepaper_c11-696141.pdfWhen I load ...

I keep getting the following syslog messages on my ASA5545:NAT/PAT pool exhausted. Unable to create connectionLU allocate xlate failedI read some other discussions that this may be a bug, but I want to make sure.sh memoryFree memory:        492880080...

Hi,I have an IPS4270 appliance (IPS4270-20-K9) in IDS mode. I am getting continuous triggers on the TCP Hijack signature and the attacker is always the proxy server. with the target of various external addresses and 1 specific internal address hostin...

Review Cisco Networking for a $25 gift card