cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1243
Views
0
Helpful
1
Replies
Highlighted

Juniper SRX to Cisco ASA Firewall Migration

Hello, 

I would like to know some features in Cisco ASA as compared to Juniper SRX: 

Following are the Juniper Configuration need to migrate into Cisco ASA. I am not getting in Cisco ASA,How to Migrate.

1. HA Configuration : 

Example:

set groups node0 system host-name <name-node0>

set groups node1 system host-name <name-node1>

set chassis cluster redundancy-group 0 node 0 priority 100

set chassis cluster redundancy-group 0 node 1 priority 1

set chassis cluster redundancy-group 1 node 0 priority 100

set chassis cluster redundancy-group 1 node 1 priority 1

set chassis cluster redundancy-group 1 interface-monitor ge-0/0/0 weight 255

#
set chassis cluster redundancy-group 1 interface-monitor ge-0/0/1 weight 255
#
set chassis cluster redundancy-group 1 interface-monitor ge-3/0/0 weight 255
#
set chassis cluster redundancy-group 1 interface-monitor ge-3/0/1 weight 255

set interfaces <node0-interface-name> gigether-options redundant-parent reth0


set interfaces reth1 redundant-ether-options redundancy-group 1  
set interfaces reth1 unit 0 family inet address 192.168.1.1/2

2) Juniper Class of Service: 


set class-of-service forwarding-classes

set class-of-service interfaces

set class-of-service scheduler-maps

set class-of-service schedulers

3) 

NAT: juniper has no nat configuration and static and source nat configuration: but in juniper is zone base firewall,

one zone has 2 interfaces, when we convert in to ciscowe need to apply NAT for every interfaces which is assign to that zone:

but NAT is shadowing because source and destination address are same only interfaces are different.

4) Firewall Filter: Juniper has Filter policies which has multiple source addresss from address and from port and from protocol

then permit.and SNMP community is called in Firewall filter for snmp access.

5) RPM: real-time Performance monitoring: 

6) IP Monitoring: IP monitoring policy which matches RPM probe then prefer routes.

I have tried to search, but not able to find anything relevant. 

please help me out, if someone has done that.


Thanks

 Shubham

1 REPLY 1
Highlighted
Advisor

1. Here is a guide of configuring active/standby failover - the most common type of ASA HA used.  There are also VPN clusters, and clusters in general.
http://www.cisco.com/c/en/us/td/docs/security/asa/asa82/configuration/guide/config/ha_active_standby.pdf

2. I don't know what Juniper class of service maps do.

3. I don't know.  There is not enough information for me to understand how to help you.

4. These sounds like plain access lists.

5. Use the ASDM for easy GUI monitoring.

6. This sounds like tracked routes.  You can combined these with "ip sla" monitoring.
http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/118962-configure-asa-00.html

Content for Community-Ad