Juniper to Cisco application layer gateway

[CSC011240286]

Hi There

I'm busy converting juniper to Cisco line by line I've used the Cisco tool but had some errors that I'm now fixing manually. how do I convert the Juniper application layer gateway to a Cisco ASA format, see below.

The (set policy id 663 application "FTP")  command is my problem

set policy id 663 name "110307-000124" from "Trust" to "VPN"  "SS-AGSERVICES" "SS-SERVERS" "FTP" permit log
set policy id 663 application "FTP"

[Vibhor Amrodia · Accepted solution]

Hi,

On the ASA device , you don't have to explicitly specify the Layer 7 policies.

You only need to enable the inspection for that specific protocol.

Thanks and Regards,

Vibhor Amrodia