Load Balancing on FPR-1010

[kostasthedelegate]

Hello, 

I have a FPR-1010 with ASA 9.13

I have two ISPs and I would like to use them simultaneously to benefit from the aggregated bw. 

How will I accomplish that?

Regards, 

Konstantinos

[Rob Ingram]

@kostasthedelegate 

Never tried it but - "You can assign multiple interfaces to a traffic zone, which lets traffic from an existing flow exit or enter the ASA on any interface within the zone. This capability allows Equal-Cost Multi-Path (ECMP) routing on the ASA as well as external load balancing of traffic to the ASA across multiple interfaces"

Reference here:

https://www.cisco.com/c/en/us/td/docs/security/asa/asa913/configuration/general/asa-913-general-config/interface-zones.html

[kostasthedelegate]

Thanks a lot @Rob Ingram 

I will try it and update!!

[kostasthedelegate]

Hello, 

I tried yesterday to create a traffic zone.  I had two interfaces. The one had a RA VPN and could not be assigned in the zone. In addition, when the zone was created the static route I had disappeared (I got a warning). 

I have two questions

How could I combine the VPN with the traffic zone?

How the routing will be set after the zone with the two interfaces?

Regards, 

Konstantinos

[kostasthedelegate]

Hello, 

Unfortunately, There is VPN configured on one interface so I cannot create a zone.

Is there any other way to implement load balancing between ISPs?

Regards, 

Kostantinos