We are getting the LU Allocate Connection Error which basically means you don't have enough memory. Cisco says to check the show memory command, which I already did and we are barely using half the available memory. However, we did a "show flash:" and it says we only have 819K of memory, so I assume that is the problem. However, there should be more free memory than it says there is. The primary ASA has the same files in flash: and the same total memory and the primary has 14M free. So, the secondary should have the same 14M free. I don't know if there are files on the secondary that are marked for deletion but aren't deleted. I can't find a "squeeze" command for the ASA. I already rebooted the ASA because it is the secondary at the moment. Has anyone seen this problem before?
