Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What are the reasons why a port-channel interface would experience output drops? There doesn't appear to be any saturation whatsoever. I have to 1 Gbps trunks etherchanneled and my network monitoring tells me that there isn't an overly large amount o...
Do drops on a trunk that occur because a vlan is being pruned increment the transmit drop counter on a show interface?Sent from Cisco Technical Support iPhone App
I have a verasign cert that I put on all my old bbsm's for guest portal access via https. I wanted to put that cert on my 5508 controller as well for the same purpose. But when I try to download it I get a message saying it failed, even though the tf...
I have been working with TAC and other's at Cisco to resolve this problem, and also have a case open with the developers. However, I thought it might be a good idea to open it up to you all to see if you had encountered this problem in the past. I am...
Well, it waits to see if it receives a superior BPDU, yes. But a switch will expect to receive BPDU's on a designated port because it knows it is connected to a switch. If it receives BPDU's on a normal edge port in forwarding mode then it will shut ...
Well... I'm not a voice expert, but if you migrate blocks of DN's at a time then you could configure a route that would send that specific block over your inter-cluster trunk. The call manager is going to choose the most specific route in the dial pl...
It should also be noted that this is a link between an access switch and a distribution switch. The distribution switch shows about 250k drops per day, while the access switch side of the link shows no drops at all.
