- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-12-2009 08:23 AM - edited 03-11-2019 08:03 AM
Hi,
I run a production two-card FWSM cluster in single context mode (Active-Standby).
I'd like to use Active-Active configuration, that's why I need to move to multiple-context mode.
Do you know any migration procedure? I have two contexts license. I guess, the best way would be moving current configuration to the admin-context. Thank you in advance for your comments!
BR,
Mihails
---------------------------
#show ver
FWSM Firewall Version 3.2(10)
...
Licensed features for this platform:
Maximum Interfaces : 256
Inside Hosts : Unlimited
Failover : Active/Active
..
Security Contexts : 2
...
------------
Solved! Go to Solution.
- Labels:
-
NGFW Firewalls
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-18-2009 03:52 PM
Your FWSM might already be configured for multiple security contexts depending on how you ordered it from Cisco. If you are upgrading, however, you might need to convert from single mode to multiple mode by following the procedures here:
http://www.cisco.com/en/US/docs/security/fwsm/fwsm22/configuration/guide/context.html#wp1081764
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-18-2009 03:52 PM
Your FWSM might already be configured for multiple security contexts depending on how you ordered it from Cisco. If you are upgrading, however, you might need to convert from single mode to multiple mode by following the procedures here:
http://www.cisco.com/en/US/docs/security/fwsm/fwsm22/configuration/guide/context.html#wp1081764
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-20-2009 09:01 AM
Hi,
Thank you, I've already discussed it with TAC support. The key issue is that current configuration moves to admin-context.
http://www.cisco.com/en/US/docs/security/fwsm/fwsm32/configuration/guide/con
txt_f.html#wp1036401
Migration is complete.
Thank you.
