cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
468
Views
0
Helpful
2
Replies

Minimum IOS version for IPS sensor v6 on CAT6500 series

JMCNEL
Level 4
Level 4

What is the recommended minimum Cisco IOS Software that will support Cisco IPS Sensor Software v6 on the CAT6509

2 Replies 2

rhermes
Level 7
Level 7

It depends on your Supervisor Engine, MSFC/PFC and capture method.

There's a good IDSM "software and hardware requirements" table here (but better elesewhere on CCO)

http://cisco.com/en/US/docs/security/ips/5.0/installation/guide/hwIdsm2.html

•Catalyst software release 7.5(1) or later with Supervisor Engine 1A with MSFC2

•Catalyst software release 7.5(1) or later with Supervisor Engine 2 with MSFC2 or PFC2

•Cisco IOS software release 12.2(14)SY with Supervisor Engine 2 with MSFC2

•Cisco IOS software release 12.1(19)E or later with Supervisor Engine 2 with MSFC2

•Cisco IOS software release 12.1(19)E1 or later with Supervisor Engine 1A with MSFC2

•Cisco IOS software release 12.2(14)SX1 with Supervisor Engine 720

jim.sellers
Level 1
Level 1

7.02(3) is good match for rev 6 SSM software. I have it running this way and its been very stable.

Review Cisco Networking for a $25 gift card