11-15-2007 07:14 AM - edited 03-10-2019 03:52 AM
What is the recommended minimum Cisco IOS Software that will support Cisco IPS Sensor Software v6 on the CAT6509
11-19-2007 12:26 PM
It depends on your Supervisor Engine, MSFC/PFC and capture method.
There's a good IDSM "software and hardware requirements" table here (but better elesewhere on CCO)
http://cisco.com/en/US/docs/security/ips/5.0/installation/guide/hwIdsm2.html
â¢Catalyst software release 7.5(1) or later with Supervisor Engine 1A with MSFC2
â¢Catalyst software release 7.5(1) or later with Supervisor Engine 2 with MSFC2 or PFC2
â¢Cisco IOS software release 12.2(14)SY with Supervisor Engine 2 with MSFC2
â¢Cisco IOS software release 12.1(19)E or later with Supervisor Engine 2 with MSFC2
â¢Cisco IOS software release 12.1(19)E1 or later with Supervisor Engine 1A with MSFC2
â¢Cisco IOS software release 12.2(14)SX1 with Supervisor Engine 720
11-28-2007 08:29 AM
7.02(3) is good match for rev 6 SSM software. I have it running this way and its been very stable.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide