Minimum level configurations can configure on Firepower Threat Defence via CLI

[Chts]

Hi

I would like to know what configurations that we can do on FTD CLI ?

I believe Management interface IP address and FMC address for managing FTD can be configurable. Other than these, can we configure configurations like HA and Code installation and  Platform settings via CLI?

[Marvin Rhoads · Accepted solution]

When it comes to configuration, the FTD cli is only used for the bootstrapping sort of operations such as the ones you mentioned and a few others. There are also some troubleshooting commands you can run.

99% of all configuration must be done via the Firepower Device Manager (local GUI) or Firepower Management Center (remote GUI) or via API.

[Chts]

Thanks for the reply Marvin.