move asa5520 failover interface

[bmarms]

I am currently using g0/3 for failover between my two ASA5520's.  I would like to move that to the management interface to free up g0/3 for a second DMZ segment.  are there any implications to doing this live other than i would only have a single ASA during the move?

[Loren Kolnes]

Hi,

If you are running stateful failover this could be an issue, see the following Cisco Support Forum thread:

https://supportforums.cisco.com/message/3106018#3106018

If you are using stateless failover then this should not be an issue.

Let me know if this answers your question.

Thanks,

Loren