MS PPTP dialin could not access network behind Cisco PIX

[chrisalbert241]

Hi! Good day to everyone.

I have recently installed a Cisco PIX firewall and for firewalling purposes now wants to configure a client VPN connection from the outside using MS PPTP. The configurations for the client VPN are ok as I double checked it. As we test the client connection through the firewall, the outside client receives an IP on the local pool I have created and the "show vpdn tunnels state" it give a connected status.

I tried to ping any IP but hences no reply was received. Are there any Microsoft configs that are need to be done or measures to be done?

Thanks,

CHRIS

[jmia]

Chris,

You need to add: fixup protocol pptp 1723 - in config mode, and save with write mem, also issue clear xlate.

For reference have a read of the following URL:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080143a5d.shtml

Hope this helps and let me know if you need further help. Pls rate all post if it helps you out.

Jay