Network Security

I have configured my VPN 3000 to assign IP addresses from a DHCP server, but it's not working. I see the DHCP discover packet go to the server but there is no reply from the server. I have an AS5300 that I configured to do the same on the same subnet...

Hi I have and issue with my 515 PIX configuration!I have a VPNGROUP with a ip pool for the clients conecctionsthe is range 10.24.51.1 - 10.24.51.24 and I create a new one with the range 10.24.51.30 - 10.24.51.32 and its configured with the same optio...

HiIam unable to take backup of VMS 2.2 (IDSMC) installed in Windows 2000 Advanced Server. On initiating a backup, it is observed that the backup completes immediately with a successful message. However, the backup folder is empty.I tried out the back...

Hi, I have next problem on my CISCO PIX 515e IOS 7.0.1.I have defined a basic PAT( i have just only valid ip address ) that working ok, but some of my users want to access some p2p application over pix.So, for they to have high id inside of p2p appli...

Dear All,I am Network Admin. for an IT company, we have few numbers of PIX firewalls spreaded between our branches...Few days ago One of those PIX Firewalls "PIX 506E" stopped working properly... I tried to access it using Console interface but faile...

Hi, I am using the IP Logging feature and have saved the file and used Ethereal to view it. Every time I open the file in Ethereal I get a message about the file being corrupt. I will usually give me the first 5 or 6 packets and then is says that the...

Hi, I have next problem on my CISCO PIX 515e IOS 7.0.1.I have defined a basic PAT( i have just only valid ip address ) that working ok, but some of my users want to access some p2p application over pix.So, for they to have high id inside of p2p appli...

I'm trying to upgrade the application image release from 3.3 to 3.4 and i get this failed message:[email protected]# upgrade ftp://[email protected]/c6svc-nam.3-4-1a.bin.gzDownloading the image...Password for [email protected]: ftp://[email protected]...

i am trying to access the xmanager from a windows pc on outside interface to a solaris server on the inside interface of the pix. I could not establish the xmanager session and i get error message xdmcp connection failed the pix iam using is 515 with...

my client has mpls connection to the internet connected on the OUTSIDE interface of the firewall. And they decided to have an ADSL to act as a backup for their internet connectivity.Ive read that we can only have a single default route on the PIX. Wh...

hi. recently my PIX515E and FO the failover always occurred. It happened about 1 time for 2 weeks. I check my log file can't get nothing. can someone help me?

Dear all,Can I find any comparison information between PIX firewall and IOS firewall in CCO?Thanks a lot in advance.mak

Hi all,Is there any information about PIX firewall vs IOS firewall in terms of features etc.Thanks and Regards,mak

We have a couple of sites that are hooked to cable connections but tunnel into out network via VPN. We have purchased several Imagistics network copiers for our different departments. At these two sites that tunnel into us via VPN, I cannot access, o...

Hi. I have two PIX 515E firewalls. Each has a connection to a router via the outside interface and on the inside to two Cat 6506's. The PIX's are connected via a failover cable and is stateful. I have an ISDN router on a DMZ on the primary PIX, which...