05-30-2012 04:33 PM - edited 03-11-2019 04:13 PM
Hi All,
Is there a way to monitor individual interfaces on a box doing multicontext etherchannel failover?
I can understand on an individual box you can add monitor-interface to the physical interface, but in multi context mode, there is only one interface (the logical etherchannel subinterface) pushed through from the system context to each of the other contexts. I've been looking around and can't work out how to get a context failover to fail if only one of the etherchannel fails.
If the other box has more active etherchannels then that's the one I want active, but can't see it at the moment.
Possibly missed something somewhere. Any ideas?
Thanks,
Gaz
Solved! Go to Solution.
06-03-2012 08:51 AM
monitor-interface will only work on "named" interfaces. So, what you are looking to do is not possible.
The member interfaces on a port-channel will not have "nameif" associated with them.
-Kureli
06-03-2012 08:51 AM
monitor-interface will only work on "named" interfaces. So, what you are looking to do is not possible.
The member interfaces on a port-channel will not have "nameif" associated with them.
-Kureli
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide