multilayer switch and firewall

[TaniaKanth85411]

Hi. 

I am struggling with cisco packet tracer, i am a beginner in this field. I just build 3 vlans for my internal network that i want to connect to my firewall. I cant seem to connect it to the firewall. I just cant figure out how i should let the firewall know that the inside vlan 1 is for the internal network. 

and on the multilayer switch the vlan 1 that i configure the firewall inside on,  wont go from down to up? please help. 

my ip address for my multilayer switch going to the firewall is 10.0.0.1/28

and my ip from the firewall into the internal network is 10.0.0.2/28 

i just pasted a file below that shows the 

[Marius Gunnerud]

My first observation is that both the switch and ASA are configured with IP 10.0.0.2.  Change the switch IP to 10.0.0.1

int vlan 1

  ip address 10.0.0.1 255.255.255.0