Multiple ISP in single ASA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-01-2021 01:58 PM
Hello,
I hope this is in the right group. I am looking to see if it is possible to have two different IPSs in the same ASA and then statically route traffic over the second ISP. I have an ASA today that is connected to my ISP and is configured to handle just our site-to-site tunnels. I want to see if I can add a second ISP and then statically route specific traffic through this ASA and out the secondary ISP. I have never had an ASA that had two different ISP let alone try to get different traffic to flow to them. Suggestions??
Brent
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-01-2021 02:17 PM
Hi Brent,
You will need to use PBR (policy based routing) for this, please go through these docs:
https://integratingit.wordpress.com/2020/03/01/asa-policy-based-routing/
There are many other examples available online that will come up on google search for policy based routing on ASA.
Regards,
Chakshu
Do rate helpful posts!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-05-2021 02:06 PM
Chakshu,
Any design guide or documentation on getting the second ISP link working without it being a failover link for the primary ISP? I think I still need to configure routing for the new link but need to make sure I do not effect routing for what is currently in production. This is my first time configuring an ASA for multiple ISPs.
Thanks,
Brent
