Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Nexus Newbie here .. We have just deployed our first two pairs of Nexus switches the old fashion way. One pair ( cisco Nexus9000 C93180YC-FX3) are service as my core switch and the other pair (cisco Nexus9000 C93108TC-FX3P) are service as my server s...
Hello, I am starting the process of upgrading our ISE 3.0 environment. It looks like I cannot go directly to 3.4 so thinking 3.3 patch 11 be a good stepping point. I can then go from 3.3 to 3.4. Based upon what I am reading I need to use the upgrade ...
OK ... I need a memory refresh. It has been so long since we originally setup our ISE environment that I have forgotten a lot of things. This is specifically addressed to wireless connections but I also think it applies to wired connections. What I a...
OK .. odd routing question .. I have a location that has an established non-Meraki VPN peer. Just an FYI the peer on the other end is Meraki but it is in a different organization. One of the address spaces in this peer is say 192.168.56.0/24. I have ...
My Renewal is up for the Z1s that are in my environment. My vendor quoted my a 1 YR renewal since they are on the EoL list for July 2025. What happens after July 2025? I am guessing it just loses support / replacement but will still continue to work?...
OK .. I think I found it and it looks like we possibly have it configured based upon the following. Can I use this in addition to Peap that we use today? We normally uncheck the certificate box so thinking I my just be missing the certificate pieces?...
Try IKEv2? We were having similar issues with connection into AWS and came down to one side being route based and the other policy based. I think the Meraki is policy based when on IKEv1 but it will use router based with IKEv2. I would have to go bac...
I always thought ACLs were only processed for traffic entering / leaving the interface where they are applied. Anything on the same wire / same VLAN would not pass through the ACL.Brent
In the non-Meraki managed stack I can set the switch priority so that the same switch is always the master and there is a pecking order for if that switch goes off line. Does the Meraki Managed flavor have that same capability?Brent
Sinelnyyk,That is what we are trying. Z3 connected to MX_A that is non-meraki VPN connected the MX_B in a different org. Trying to get Z3 access to network behind MX_B. We were thinking it was something routing related as the MX_B network was not in ...
