12-25-2010 10:23 PM - edited 02-21-2020 04:11 AM
Hi,
We have deployed a Cisco NAC Agent in our network with GPO update... The deployment model is L3 OOB / Real IP Gateway.
The issue is that, we need to put the IP address in each host manually to start communicating with Cisco NAC Manager.
Is there any way to make it automatic?
Regards,
Mubasher
12-28-2010 02:21 AM
Hi,
You can also distribute the NACAgentCFG.xml file with that value set.
Please find here detailed info regarding this file:
For the discovery host value you need only to edit the field:
HTH,
Tiago
--
If this helps you and/or answers your question please mark the question as "answered" and/or rate it, so other users can easily find it.
01-23-2011 12:32 AM
06-19-2013 07:42 AM
Hi Mubashir,
I faced the same problem with cisco ISE and Tiago's response actually helped see below.
" You can also distribute the NACAgentCFG.xml file with that value set.
Please find here detailed info regarding this file:
In that link, read the section: Agent Customization Settings
From a NAC agent that has successfully been deployed with the IP configured , go to the NAC agent installation folder
C:\Program Files (x86)\Cisco\Cisco NAC Agent , and copy the NACAgentCFG.xml , open with wordpad and edit the line
Then place the edited NACAgent.xml file in the same folder as the one where your GPO will pick the agent from. When the Agent is installed , it automatically picks the configs from the .xml file.
Regards,
Henry
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide