cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
688
Views
0
Helpful
4
Replies

NAC Issue

emadehsan
Level 1
Level 1

hello guys;

I have nac 3310 with lite manager license,

there is no any switch managment menu on the CAM.

how can i handle snmp traps from swiches without this menu?

or is any other type of development?

thnx

4 Replies 4

pmccubbin
Level 5
Level 5

Hi Ehsan,

Please take another look in the CAM and let's be clear about the fact you are doing an Out-of-Band implementation of NAC.

Look for Switch Management-->Profiles.

You can use the default profile and add your first switch. You must then add a switch profile for each model of Cisco switch you manage.

Make sure that you configure the switch model, the SNMP port, and the SNMP read/write community strings to match the configuration on each switch.

Hope this helps.

Best,

Paul

Dear paul

my problem is that i have no switch managment section on my cam :(

Hi Ehsan,

Here's a dumb question which I should have asked you first: Have you added the license for a CAS?

You need to add the OOB CAS to your CAM and then you can manage a switch.

Hope this helps.

Best,

Paul

paqett001
Level 1
Level 1

Sounds like the same problem I had. I opened a TAC case and I was issued a new license. Both licenses need to be associated to the MAC address of the CAM. I had one associated to the CAS and one to the CAM. I understand it is a pretty common problem.

Review Cisco Networking for a $25 gift card