06-17-2017 01:09 AM - edited 03-12-2019 02:35 AM
Dears,
I am following the below link to understand the NAT above 8.3 and I have fall into one question, when we should use dynamic & static keyword in the TWICE or MANUAL NAT commands. .
As I know the dynamic keyword is for dynamic nat and static keyword is for static nat but in the below statement why it was necessary to use the dynamic keyword
nat (inside,dmz) source dynamic NET-10.129.100.47 obj-172.30.52.98 destination static obj-172.16.3.0 obj-172.16.3.0
06-17-2017 01:37 AM
Hi Jack,
On newer ASA versions we have the ability to do Twice NAT which means we can use one
In this case host 10.129.100.47 is getting dynamically
Remember we cannot use dynamic NAT for destination translation.
Regards,
Aditya
Please rate helpful answers and mark correct answers.
06-17-2017 02:43 AM
Dear aditya,
our source 10.129.100.47 want to reach a destination 172.16.3.0 , so as per your statement it is dynamically natted means what ???
It is natting with one ip 172.30.52.98 and not a pool of ip address so instead of dynamic I would use there a static keyword
Still I m confused what dynamic natting is happening in the statement what I see is all static one-to-one
06-28-2017 07:23 AM
Dears,
Anybody can help me with the above query
thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide