Solved: NAT translation for each IP

GeorgeBab · ‎10-18-2018

Hello ,

I have a Firewall 5545 and i would like to take output for each NAT translation (Nat Table). Can i have some help on this please ?

I tried "show xlate" command but i have no output. Do you have any other idea ?

Thanks ,

George

Ajay Saini · ‎10-21-2018

Hello,

If 'show xlate' does not throw any output then maybe there are no translations currently. You can check for static and dynamic translations by checking output of 'sh xlate type static' or 'sh xlate type dynamic' .

I checked in my environment and it works perfectly.

HTH
AJ

View solution in original post

Ajay Saini · ‎10-21-2018

Hello,

If 'show xlate' does not throw any output then maybe there are no translations currently. You can check for static and dynamic translations by checking output of 'sh xlate type static' or 'sh xlate type dynamic' .

I checked in my environment and it works perfectly.

HTH
AJ

mkazam001 · ‎11-03-2018

sh xlate should allow you to see all active nat translations through the asa.

you could try sh conn to see all active connections through the asa.

hope that helps!

azam