nating between internet clients to DVR

[hanyawad]

Hello,

i have a DVR installed inside my network  with local ip address 10.0.0.117/24 and i need to access it from the internet. there is a pix 515e (ios ver. 6.2) between the internet and my internal network. i've configured NAT from inside to outside to allow my internal clients to access the internet. but i need to allow external clients from the internet to access the DVR. i've tried to configure it on my pix but i found it doesn't have more options for nating like ASA.

is there any way to do that on pix and if so what the correct commands to do that. thanks

[Julio Carvajal]

Hello,

Yes, they are

static (inside,outside) public_ip_DVR internal_ip_DVR

access-list outside_in permit ip any host public_ip_DVR

access-group outside_in in interface outside

You can be as restrictive as you want with the ACL

Any other question.Sure.. Just remember to rate my answers..

Julio

[hanyawad]

hi,

thanks for your reply.

after i typed these commands i lost the internet connection on my LAN. by the way my DVR uses local ip address and the external client is mobile. any advice please. thanks

Labib

[Julio Carvajal]

Hello,

Can you use a different and dedicated ip address for the DVR different from the global the inside users use.....

[hanyawad]

Hi,

i don't have DMZ network. just an internal network of 10.0.0.0 that has the internal clients and DVR one of them. thanks

Labib

[Julio Carvajal · Accepted solution]

Hello,

I think you do not understand me....

Can you use a different and dedicated PUBLIC ip address for the DVR different from the global the inside users use.....

[hanyawad]

thanks so much i got it