Need help converting Pix 506E config to 871W router

[s-acharya]

Just received a new Cisco 871W to replace Pix 506E (firewall + SiteToSite VPN). I downloaded new IOS that supports multiple Vlans and installed in 871W. I try using ASDM express to config the router but i was unable to copy or match config form pix to router, obviously commands are different.

I need your help converting this simple basic config to adopt to 871W. Please help.

thanks

[vkapoor5]

This is fairly a straightforward document that explains the IPSec between a Cisco IOS router and a PIX. By looking at both the configs, you an easly draw out the corresponding commands. Take a look.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094498.shtml

You can also see other similar documents here at;

http://www.cisco.com/en/US/tech/tk583/tk372/tech_configuration_examples_list.html