New Firepower 1120

[ArnoldB]

I have a new Firewall 1120 and can't connect to Firepower Device Manager. According to the status lights it is connected to the cloud, failover pair operating normally, & there's activity on the SSD. Any ideas?

[Rob Ingram]

@ArnoldB If the failover pair is operating normally how did you configure this without accessing FDM GUI?

What physical interface is your laptop connected to, the management interface? If so do you get an IP address in the 192.168.45.x range (default)?

[MHM Cisco World]

Can you more elaborate

Thanks 

MHM

[Marvin Rhoads]

What @Rob Ingram said, plus from the cli (ssh or console) what does the "show managers" command show you?

[ArnoldB]

Here’s some background:

First, I apologize If I seem a little slow, this is definitely a learning experience for me.

This is essentially for a home setup; my home office setup has expanded to include some of my co-workers.

ISP: AT&T (BGW320)

The Firepower 1120 brand new, fresh out of the box, from Cisco; ordered via CDW. I haven’t configured or altered anything.
     Status Light: Green, flashing slowly
     Failover Pair Light: Green, Solid
     SSD Light: Green, flashing

IP address when plugged into BGW320: 192.168.1.220
IP address when plugged in Management Port: 169.254.152.45
IP address when plugged into 1/2 port: 192.168.95.5