10-17-2018 01:48 PM - edited 02-21-2020 08:22 AM
I bought an asa 5505 but with version 7.4 ... I neede to make it work but so far I can not even ping ..So I can not upgrade to version 9.4
I don't even know if it 's a subnet issue but I keep getting no route found
I don't if the problem is a wrong IP address or wrong command .Can you please check and give me an advice? I am desperately trying to find a solution
Thank you in advance
Victor
10-17-2018 02:12 PM
What physical ports (Eth0/0, Eth 0/1) are the inside and outside cables connected to? I see that Eth0/0 (vlan 2) and Eth0/1 shut down. Unshut the physical interfaces so that the vlan interfaces come up as well.
10-19-2018 09:15 AM
10-19-2018 09:18 AM
Good afternoon..
I am new in Cisco ASA 5505.I couldn't make it work so I reload the asa.
I am trying to make a route so it can ping and reach the computer, so eventually, I can upload the version 9.2.x.
I bought this device 2 weeks ago and I am not able to use it.
This is the new message:Cannot add routes, connected route exists
But either with that message, I can NOT ping from the firewall to computer, and that means I can NOT upload the latest asa image
Can anybody help me, please?
This is frustrating...
Thank you for any help in advance
Victor
10-19-2018 06:42 PM
10-20-2018 09:13 AM
Hello Venka..
I have done all of that and nothing works. Please check the Blue screen..
I can not ping the router either the computer.
I am stuck and I am desperate. I checked the cables as well. I check the route table and I see the route, but I can not ping.
I have a ver y basic topology as you can see.
Any other suggestions?
Thanks in advance anyway
Regards..
Victor
10-21-2018 10:55 AM
11-07-2018 11:31 AM - edited 11-07-2018 11:44 AM
did it get fixed?
did you check any firewall issue on your pc. thats blocking incoming connection.
or try to change vlan number and see what happens.
-------
int vlan 1
nameif inside
security-level 100
ip add 10.0.0.1 255.255.255.0
no shut
int vlan 2
nameif outside
security-level 0
ip add 68.191.43.172 255.255.255.0
no shut
!
int e0/0
switchport access vlan 2
no shut
int e0/1
switchport access vlan 1
no shut
!
route outside 0.0.0.0 0.0.0.0 68.191.43.1(use your defualt gateway IP-address)
!
Above configuration should work well, you should be able to ping your firewall local
ip address and any ip-address directly connected to that interface.
Note: As 'inside' interface as security-level 100, it should allow all ip traffic.
- check arp entries in firewall, you should have remote pc arp in it.
----------------------
sorry i was busy with work and had no time check the updates over here.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide