OCC Tool Question

[Thomas Reiling]

I'm trying to use the Outbound/Conduit Converstion tool they way it reads in the Migration Guide.  I use the following command at the command prompt:

occ old_config new_config

I get nothing.  I have my old config in the same directory as the occ.exe file.  Am I missing something?

Thank you,

Thomas

[csaxena]

Hello Thomas,

Here is a link which expains use of conversion tool :

http://www.cisco.com/en/US/products/sw/cscowork/ps3992/products_user_guide_chapter09186a008014b1e5.html#998837

Another good link which you can refer for use of GUI/CLI:

http://www.cisco.com/en/US/docs/security/asa/migration/guide/pix2asa.html

(Converting a Cisco PIX Configuration to a Cisco ASA 5500 Series Configuration Section)

Hope this helps. Please reply back if you need any further assistance.

Regards,
Chirag
P.S.: Please mark this thread as answered if you feel your query is answered. Do rate helpful posts.

[patrick.crum]

Try to run the bare bone command of occ.exe filename and nothing else. I couldnt get it to work by doing the recommended. Occ file1 output dilename

Sent from Cisco Technical Support iPhone App

[Thomas Reiling]

I figured it out.  I was not putting in the ">" character between the two file names.

[csaxena]

Glad it is working now. Please mark this post answered for others to refer in future.

Regards,

Chirag

[ekwasny]

Thank youy so much. Yes, you have to put a ">" between the input and output file names.

How long will this go on before Cisco desides to add the change to the Migration Guide.....

Thanks Again.....   EDK

[csaxena]

Thanks EDK for bring it to our notice. I shall forward the info the Business Unit for the same.

Regards,
Chirag