Network Security

Dear all,This is regarding the telnet issue to ASA.Currently I am able to telnet from inside network to ASA with folowing configuration..telnet 10.0.2.0 255.255.255.0 insideNow I want telnet from outside interface but unable to access..telnet 10.0.5....

IOS 12.4(24)T22821#sho ip nat nvi translations | inc 5190tcp x.x.x.x:1082  10.96.33.31:1082   64.12.28.238:5190  64.12.28.238:51902821#clear ip nat nvi translation tcp inside x.x.x.x 1082 10.96.33.31 1082 outside 64.12.28.238 5190  64.12.28.238 5190%...

When will (or is it already?) NAC be officially supported running as a VM?4.8.1 installs just fine and appears to run well (I was using an eval license) on vSphere 4.1.-Mike

can some one help me with the follwingi have ASA5510-CSC10-K9 , does this product has failover license .??i have seen ASA 5510 SEC + bundle do have failover license . but if i order for ASA5510-CSC10-K9  do i have to ask for failover license sepratel...

Hello,I know very little about ASAs and FWSMs and work in an environment where we have both. Lately, I've been asked to get more involved in maintaining the firewalls, but no one will help me understand the basics. I've done some searching around and...

After running the FSCK command on the FWSM Disk: I have orphaned files remaining but am now unable to delete them?On running the FSCK command it did ask for confirmation not to delete these files which was default, but as not knowing what this would ...

HiCan anybody help me with a question I have regarding port redirection? Can we port forward two private IPs to the same public IP ?I have the following statementsstatic (inside,outside) tcp 1.1.1.1 https 192.168.15.112 https netmask 255.255.255.255 ...

Hi,is it correct that the cisco asa can't be a mld querier?I've enabled mld snooping on my backbone but without a querier in each vlan it makes no sense Any chance to get better mld support in the next firmware release?

We are using an ASA 5510 as our gateway to our ISP.  All of our VOIP traffic is sent to an Internet SIP provider for our outbound calls.  Our pipe to the Internet is 100Mbps metro ethernet.  I am trying to find a way to provide QoS for this traffic s...

Welcome to the Cisco Networking Professionals Ask the Expert conversation. This is an opportunity to get an update on the Network Admission Control components and how they fit together in inband/virtual gateway/Layer 2 deployments with Cisco subject ...

I am setting up a new ASA 5510 on our inside network so that we can terminate our VPN connections on this ASA. I can get the VPN to work fine however I noticed that once I turned on my VPN profiles now when I try to access the ASDM I'm getting the VP...

Hi Guys, I am looking at the config on a ASA for someone and what I am seeing is lot of Static NATing to the same Subnets netween diffrent zones likestatic (dialdmz,dmz) 10.32.144.0 10.32.144.0 netmask 255.255.255.0static (dialdmz,dmz) 10.32.145.0 10...

Hi,I have an  ASA 5510 working in Routed mode for a company with the following networks. everything works fine as desired.Below are the interfaces, security and  ip addresses .Ethernet0/0   DC_SERVER   security-level 100ip address 172.16.11.12 255.25...