- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-19-2012 05:20 AM - edited 03-11-2019 03:16 PM
What is mean by display collisions numbers on interface of ASA Firewall?
Thanks in advance..
Solved! Go to Solution.
- Labels:
-
NGFW Firewalls
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-19-2012 10:47 PM
Hi Abhinay,
If you are looking for what are collisions in the show interface output on ASA, they occur when the ASA and the connected device try sending traffic at the same time. Please check the following link for more information :
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfd6.shtml
http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008009491c.shtml
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-19-2012 10:47 PM
Hi Abhinay,
If you are looking for what are collisions in the show interface output on ASA, they occur when the ASA and the connected device try sending traffic at the same time. Please check the following link for more information :
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfd6.shtml
http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008009491c.shtml
Thanks.
