Hi,
We have a project that consists on implementing FTD devices using FirePOWER Management Center (FMC 4000). In the implementation we need to configure packet marking using route map:
Here the configuration on the cisco ASA:
!
access-list Data {standard | extended} {permit | deny } ………
!
route-map QoS-Classification permit
match ip address Data
set ip dscp af31
!
interface GigabitEthernet0/0
policy-route route-map QoS-Classification
!
!
So we would like to implement this configuration using FMC GUI. Could you please help us to find the right method to configure it.
Thanks,