PAT configuration for 9.x ASA

[Curtis Fong]

Hi everyone,

I've been looking for configuration examples to PAT two different IP addresses - one inside, the other outside, to a single IP address.  If anyone has an example of how to do this I would really appreciate it.

[nicholas nelson]

Curtis Fong,

You can find some sample configuration guides by going to cisco.com/go/support and looking up the product config guide. Below is a sample guide from the 5500X series that has an extensive writeup on doing a NAT setup for a single IP that can introduce PAT. 

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/115904-asa-config-dmz-00.html

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/111842-asa-dynamic-pat-00.html