PIX 501 firewall setup

[mipd]

Hi,

I just installed a PIX 501 using the PDM software. I have two networks and want to use the 501 as a firewall between them,allowing one way traffic.

I set the inside to 192.168.../24 and the outside to 195.1.../24

I can ping the 192 network from the 192 side but can not ping through to the 195 network.

I can not ping the 195 address from the 195 network and as expected, it will not ping through to the 192 network.

The PDM software will not allow me to enter the PIX 501 giving "page can not be displayed" message.

What do I do?

Thanks!

[jackko]

what exactly you try to achieve? pinging? if so, type the commands below under cli (not pdm)

access-l xxx permit icmp any any

access-g in inter outside