Network Security

Hi,I have a PIX535-R.I'd like to use it in failover.Is it possible to install the failover license with an activation-key, or do I need to change the PIX for an other (unrestricted).If it is possible to install the failover license, how can I obtain ...

Hi,I would like to know who can tell me if I can add OSPF to a connection between a router and a PIX. Here is the link that made me think.http://cisco.com/en/US/customer/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094498.shtmlo...

i have a pix 506e in our data center and a pix 501 in a remote office. they are connected together with a pix to pix vpn. can we limit the bandwidth available from the devices behind the 506 to upload to a device behind the 501 on port 5000 to less t...

If somebody asks a question that what is special in PIX firewall which is not in router's ACL control lists.I mean the benefits of using PIX firewall over router's ACL. Pls help me to differentiate this.

I feel funny about asking this question since I have ANSWERED some much more difficult. However, I am having an issue loading PDM from a tftp server onto the PIX...I know that PDM is already on it, but I am having a problem getting it going..Any sugg...

I have a 501 firewall for the past couple of years at a client site. In recent months they have a growing problem of a random users not able to connect to the Internet. Typically 1-2 users are able to connect in the morning and then the next user is ...

Hello,Could anyone help me with a configuration for a Cisco 837 router and a Cisco PIX 501, while getting only one IP address from the ISP, because of the use of ADSL as connection?Must I configure the 837 router as a bridge by entering "no ip routin...

Hi, in my company I have 3 routers Cisco2600. For 2 of this router I have configure a HSRP protocol with wirtual IP 192.168.3.10/22 (the physical IP address of the ethernet interface is 192.168.1.10/22 and 192.168.2.10/22). The other router have this...

I found the link below about how to set up an ACL for blocking P2P file sharing. My question is that I was under the impression that the PIX blocked all ports coming in by default and that the only ports allowed are 80 and those defined by the fixup ...

I have a test ids executing a shun to a PIX over ssh. We see the signature fire, the sensor status shows the ip address of the offending host being shunned, and a time limit of 15 minutes which we have set. On the PIX, we see the ids sensor logged in...

Has anyone else noticed the Chemtrails in the side picture of the PDM 3.0(1) Startup Wizard?Are they suppost to be Chemtrails? or something else entirely? perhaps something artistic?CheersRob

Hi folks!We're a small company running a PIX 501 device as our corporate firewall. We have a DMZ set up inside our firewall, with the bulk of our internal network being behind a Linksys router - we have a webserver sitting in the DMZ at the moment. O...