cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
580
Views
5
Helpful
4
Replies

PIX 506 E + Daylight Saving time

mcmcomcisco
Level 1
Level 1

Do we need to do anything to our PIX 506 E in order to patch it for the new DST?

if so where do i go about getting the patch.

thanks in advance,

mcm

4 Replies 4

vitripat
Level 7
Level 7

There are two options.

- You can use "clock summer-time" command to specify the new date and time.

- Upgrade PIX to atleast version 6.3.5(123) which will have the patch for DST. You need to get in touch with TAC who can publish the image for you.

Hope this helps.

Regards,

Vibhor.

thanks for the help. One more question.

I have no clue how to even get into my PIX this was put in place before i came to this company and i have never used it before. I have the access passwords, etc but i dont even know where to go to log into it. Can you point me to a document or some instructions on how to access it. Also whats a TAC?

thanks,

mcm

You can use following link to get access to PIX console:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/63qsg/506quick.htm#wp31017

TAC -- Technical Assistane Center.

This is a place where you'll find experts on various technologies to assist you. If you need assistance with PIX, you can call TAC and open a case with PIX team. All you need to have is a valid contract with Cisco, or your PIX must be under warranty to get software support on it.

http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml

Hope that helps.

Regards,

Vibhor.

you can probably telnet to it

telnet IP_address

Telnet is most likely enabled.

Good luck.

Julio

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: