Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I cannot seem to set my PIX to allow http access (ie: the web interface). I tried http server enable at the command line and it does not work. when i type "show http" i see the following: http server disabled 192.168.8.0 255.255.255 0 inside and wh...
Hi i have finally managed to get into my PIX Firewall although i can only seem to telnet into it. I have to do some networking changes regarding our internal networks. Currently my PIX uses three external IP Addresses and translates them into addre...
Hi all, We have a CISCO PIX 560e in our office. Connected between the Wall and the router. I have no idea how to even use this thing or even how to check if its working properly. It was setup before i came here and i have never had a need to touch...
thanks i managed to get it to work. Now for another stupid question. From web interface i now am asked for username and password. where in telnet i only provide a password. All i have is the passwords, i dont know my username! is there a default us...
thanks for all your help. Slowly but surely im working on it. Still can't connect and i have two more small questions. 1) Can you access this via wireless or do i have to have a ethernet plug in my computer 2) Can the internal ip address of the PIX...
great thanks a lot for your help. Just to clarify. In order to connect to the pix via Web Browser interface i need to directly plug a computer into the PIX on the Ethernet 1 port correct? I cannot pass through a router for this? Just wondering be...
thanks for the help. One more question. I have no clue how to even get into my PIX this was put in place before i came to this company and i have never used it before. I have the access passwords, etc but i dont even know where to go to log into i...
