cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
290
Views
0
Helpful
1
Replies

PIX 506E and VPNGgroup Config!! Help!!

brian-henry
Level 4
Level 4

I have a PIX 506E and I have it attached to a cable modem and had it configured to use an IAS server for authentication as documented. It was working fine until I switched my IP Addresses from my provider and now I can get out to the Internet and can connect into my exchange and web servers but my VPN tunnel does not work.

I get a prompt for authentication and it sits and spins saying securring communications but it never does.

I get the following error when on my client

17:42:32.046 02/10/05 Sev=Warning/3 IKE/0xA300004B

Received a NOTIFY message with an invalid protocol id (0)

I can e-mail my config to anyone that might be able to help.

1 Reply 1

brian-henry
Level 4
Level 4

I just had to reload the PIX! Is there an easier way or a command that can be used instead of reloading the whole PIX?

Review Cisco Networking for a $25 gift card